- Packages required for pppoe server on mikrotik routeros password#
- Packages required for pppoe server on mikrotik routeros license#
The optimal value is the MTU of the interface the tunnel is working over decreased by 20 (so, for 1500-byte ethernet link, set the MTU to 1480 to avoid fragmentation of packets) mtu ( integer default: 1480) – Maximum Transmission Unit. Some connection instructions may use the form where the “phone number”, such as “MikroTik_AC\mt1”, to indicate that “MikroTik_AC” is the access concentrator name and “mt1” is the service name.Īc-name ( text default: “”) – this may be left blank and the client will connect to any access concentrator that offers the “service” name selected add-default-route (yes | no default: no) – whether to add a default route automatically allow ( multiple choice: mschap2, mschap1, chap, pap default: mschap2, mschap1, chap, pap) – the protocol to allow the client to use for authentication dial-on-demand (yes | no default: no) – connects to AC only when outbound traffic is generated and disconnects when there is no traffic for the period set in the idle-timeout value interface ( name) – interface the PPPoE server can be connected through mru ( integer default: 1480) – Maximum Receive Unit. It is fully compatible with the MikroTik PPPoE server (access concentrator).
The PPPoE client supports high-speed connections. Maximum of 65535 connections is supported. 9KiB (plus extra 10KiB for packet queue, if data rate limitation is used) for each connection) and CPU power. Hardware usage: PPPoE server may require additional RAM (uses approx. Standards and Technologies: PPPoE (RFC 2516) Submenu level: /interface pppoe-server, /interface pppoe-client
Packages required for pppoe server on mikrotik routeros license#
License required: Level1 (limited to 1 interface), Level3 (limited to 200 interfaces), Level4 (limited to 200 interfaces), Level5 (limited to 500 interfaces), Level6 (unlimited) interface pppoe-server server add service-name=internet interface=wlan1 \ ppp secret add name=mike password=123 service=pppoe profile=pppoe-profile
Packages required for pppoe server on mikrotik routeros password#
Add a user with username mike and password 123:.ppp profile add name="pppoe-profile" local-address=10.1.1.1 remote-address=pppoe-pool Add PPP profile, called pppoe-profile where local-address will be the router’s address and clients will have an address from pppoe-pool:.
Generally speaking, PPPoE is used to hand out IP addresses to clients based on the user (and workstation, if desired) authentication as opposed to workstation only authentication, when static IP addresses or DHCP are used. The difference between them is expressed in transport method: PPPoE employs Ethernet instead of modem connection. PPPoE is an extension of the standard Point to Point Protocol (PPP). Currently PPPoE is used mainly by ISPs to control client connections for xDSL and cable modems as well as plain Ethernet networks. The PPPoE (Point to Point Protocol over Ethernet) protocol provides extensive user management, network management and accounting benefits to ISPs and network administrators.